Navigation | ||
My WhyNot? | ||
Icon Key | ||||||||||||
The community's level of support for this idea is...
| ||||||||||||
Thread cutter | |||||||||||||||||
Those little spools of plastic covered garden wire all contain a simple sheet metal cutting gadget which permits the wire to be cut to an appropriate length. When I sew I always have to look around for a scissor to cut the thread as a torn thread leaves splayed fibers which make it difficult to get the thread through the eye of the needle. Wetting the thread to join the fibers always leaves a torn end with one or two disobedient filaments that frustrate threading the needle. A scissor solves that but if each spool had a small version of the garden wire cutter on one end,which would still permit a through hole on the spool for mounting on a sewing machine, it would be a convenience. A simpler cutter would be the one on a dispenser for dental floss which might work just as well.
sand, Apr 13 2009
What do you think of this idea or comment?
| |||||||||||||||||
I agree
No opinion
I disagree![[SPAM]](http://www.whynot.net/images/flagasspam.png)
Flag as spamUsers who liked this idea also liked: | ||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||
Add your comment
I would think that a simple blade cutter would fray the end of the thread a lot more than sharp scissors, but it would depend on the design. I don't know how the wire cutter you're talking about works, but the dental floss cutter would definitely fray the end. This might be a problem for sewing thread, but a cutter on a spool of all-purpose twine would be handy. For most uses, it wouldn't matter if the twine unraveled a bit on the end.
OTOH, it wouldn't matter if the thread frays if you have a needle threader. I have one exactly like the one in the link. It works great. I suppose the manufacturers could have a threader like that attached to each spool too, along with a cutter, but I doubt they would do it. I find it annoying that some spools don't even have a little slit cut into the edge to hold the end of thread after you're done with it.